玻璃钢电缆保护套管的施工规范
Construction Specification for Fiberglass Reinforced Plastic Cable Protection Bushing
(1)保护管标准长度为4米/6米,采用橡胶圈承插式接口连接或管件粘合连接,原则上以直埋敷设为主
(1) The standard length of protective pipe is 4 meters/6 meters. It adopts rubber ring socket zhujian.37ix.com.cnshidiaocs.37ix.com.cnshidiaorw.37ix.com.cn suliaotp.37ix.com.cnsujiaopvc.37ix.com.cnsujiaodb.37ix.com.cnconnection or pipe fittings bonding connection. In principle, direct burial laying is the main method.
(2)管材埋深一般应离地面1米及以下
(2) Pipe burial depth should generally be less than 1 metre above the ground.
(3)管材的搬运
(3) Pipe handling
玻璃钢电缆保护管装卸注意事项玻璃钢电缆保护管装卸注意事项
Cautions for loading and unloading of FRP cable protection tube
A.管件装车搬运时,要防止管材散捆掉落
A. When loading and transporting pipe fittings, it is necessary to prevent loose bundles from falling off.
B.卸管材时,禁止将管材从车上往下扔,防止管材的端头损伤。玻管材的保管
B. When unloading the pipe, it is forbidden to throw the pipe down from the car to prevent the end of the pipe from being damaged. Storage of Glass Pipe
A.管材应放在凹凸少的较平坦的地方保管,否则有可能使管材被泥水污损
A. Pipes should be kept in a flat place with less concave and convex, otherwise they may be contaminated by mud and water.
B.管材堆放采用进字型叠法或单根依固,防止管子散捆
B. Pipe stacking should adopt the type-in stacking method or single sticking method to prevent pipe bundling