玻璃钢电缆保护套管的施工规范

Construction specification for fiberglass cable protection casing

(1)保护管标准长度为4米/6米,采用橡胶圈承插式接口连接或管件粘合连接,原则上以直埋敷设为主

(1) the standard length of the protective pipe is 4 m /6 meters, and the rubber ring socket connector is used to connect the joint or the pipe fittings. In principle, it is directly buried and laid.

(2)管材埋深一般应离地面1米及以下

(2) the buried depth of pipes should generally be 1 meters from the ground and below the ground

(3)管材的搬运

(3) handling of pipes

A.管件装车搬运时,要防止管材散捆掉落

When the A. pipe is loaded, the pipe bundles should be prevented from falling.

B.卸管材时,禁止将管材从车上往下扔,防止管材的端头损伤。

When B. is unloaded, the pipe is forbidden to be thrown from the car to prevent the end damage of the pipe.